BEHRINGER X32 USB RETURN PATCH
BEHRINGER X32 USB RETURN SERIES

BEHRINGER X32 USB RETURN PATCH

The sends to the WFS can be patched from the post-fader direct-outs on the input channels to the digital audio port.įor the returns it is possible to patch the digital audio port to ext. These consoles have a port of a digital audio interface: ADAT, MADI, Dante… The total number of sends and returns to/from the WFS processing can be no greater than the total number of input channels. There are as many outputs as mix channels. The latter options suits us.įor the return from the WFS process since there is no possibility to come straight back into a mix channel we have to assign the USB returns to unused input channels and then send the signal to mix channels. Either all signals are taken at the preamp or are post-fader. There are two modes to choose from for the USB. A stage box gives a little more flexibility. input channel 2 can only be assigned to local XLR 2 or USB channel #2.

Each input can either be patched to the corresponding analogue or USB input: ie.

BEHRINGER X32 USB RETURN SERIES

This series of consoles has been fitted with a USB port with as many tracks as there are on each desk. The total number of inputs and outputs can not exceed 48.ĭocumentation for TF series block diagram page 103 You can patch the post-fader direct-outs to the sends of the USB port and the returns to unused input channels. Only the number of XLRs at the rear and the number of faders vary. The number of input and mix channels is the same on all sizes. There is also an option for a Dante card that can be used for a stage rack or any other Dante device. This series of consoles has a SUB port that can transport up to 34 channels each way. There can only be 16 sends to the WFS processing and as many returns.ĭocumentation for 01V96i (owner’s manual), block diagram page 68. They can be then either sent directly to the amplifiers from the direct-outs of these channels or to mix channels. They have to be patched to unused input channels.

They cannot be patched to the cascade in of the mix channels. The returns of the WFS processing are found on the returns of the USB port. The post-fader direct-outs of input channels can be assigned to the sends of the USB port. In this case the slot can be used to have more outputs for the speakers or go to 96kHz. The last generation of the 01V96 has been fitted with an USB port to send and receive upto 16 channels each way. There are up to 14 physical outputs available on the desk: 2 master + 4 omni + 8 ADAT at 48kHz.ĭocumentation for 01V96 block diagram page 325

There is a maximum of 16 sends and 16 returns to/from the WFS processor. If some of the mix channels are used for effects for instance, you can route some of the WFS returns to unused input tracks and use their direct-out to drive the amplifiers. Once again this is limited to 16 channels. The returns from the WFS can be either patched to the cascade input of the mix (aux and bus) channels of the console. There is a maximum of 16 possible tracks.

The post-fader direct-out connection of each channel will be routed to the slot outputs. The input port can be used to play some tracks on a computer. The built-in ADAT output port of the console will be used to connect the speakers through an ADAT to analogue converter. Here we have to use an add-on card: ADAT, MADI or Dante for instance. Yamaha 01V96, 01V96i & TF, Allen&Heath Qu24 / Qu32 & GLD80 / GLD112, Midas M32 & Behringer X32, Soundcraft Si, Presonus StudioLive v3, Roland m-400. Here are a few configuration examples of affordable consoles (between 2000€ and 5000€ roughly).

Behringer x32 usb return